It depends on what you mean. Do you want actual tab characters in your file to appear 4 spaces wide, or by "tab" do you actually mean an indent, generated by pressing the tab key, which would result in the file literally containing (up to) 4 space characters for each "tab" you type?
Depending on your answer, one of the following sets of
settings should work for you:
For tab characters that appear 4-spaces-wide:
If you're using actual tab character in your source code you probably also want these settings (these are actually the defaults, but you may want to set them defensively):
set softtabstop=0 noexpandtab
Finally, if you want an indent to correspond to a single tab, you should also use:
For indents that consist of 4 space characters but are entered with the tab key:
set tabstop=8 softtabstop=0 expandtab shiftwidth=4 smarttab
To make the above settings permanent add
these lines to your vimrc.
In case you need to make adjustments, or would simply like to understand what these options all mean, here's a breakdown of what each option means:
The width of a hard tabstop measured in "spaces" -- effectively the (maximum) width of an actual tab character.
The size of an "indent". It's also measured in spaces, so if your code base indents with tab characters then you want
shiftwidth to equal the number of tab characters times
tabstop. This is also used by things like the
Setting this to a non-zero value other than
tabstop will make the tab key (in insert mode)
insert a combination of spaces (and possibly tabs) to simulate tab stops at this width.
Enabling this will make the tab key (in insert mode) insert spaces instead of
tab characters. This also affects the behavior of the
Enabling this will make the tab key (in insert mode) insert spaces or tabs to
go to the next indent
of the next tabstop when the cursor is at the beginning of a line (i.e. the
only preceding characters are whitespace).
For more details on any of these see
:help 'optionname' in vim (e.g.